What is the Italian word for 'moron'.

Started by roy-nexus-6, September 17, 2009, 02:48:08 AM

Previous topic - Next topic

roy-nexus-6

I installed the Ducati Crankcase Breather Vent Filter Kit from TPO 2 days ago: I had to remove the tank to do so (I ride an S4, and Ducati made NO attempt whatsoever to neaten up the mares nest of host and wiring on the 916 engine).

Long story short - I am not sure if I have reconnected the two fuel lines correctly. They are labelled M and R respectively - which stands for two Italian words (of which I am ignorant) that would normally be printed on a sticker on the underside of the tank (no such sticker on my bike). :-\

Any advice would be appreciated. [thumbsup]

The two lines go into the throttle bodies.

(1)Tank underside: TWO outlets. I have installed hose R onto the outlet that is closest to the front of the bike; hose M is on the outlet closer to the back of the bike.
(2)Throttle body in profile. Hose M (labelled) enters the body closest to the front of the bike; hose R attaches to the body closest to the rear.






DucHead

M = mendata(?) (feed) and R = ritorno (return).

I labeled mine with a sharpie before dismantling, but I'm away from my bike and I'm not much help.   :P

Hopefully, Speeddog will answer, as he's an expert and he has an S4.

However, if you fit quick disconnects, orient the M and R quick disconnects in different directions, and you'll never get them confused again.
'05 S4R (>47k mi); '04 Bandit 1200 (>92k mi; sold); '02 Bandit 1200 (>11k mi); '97 Bandit 1200 (2k mi); '13 FJR1300 (1k mi); IBA #28454 "45"

weemonster


Simon

you have connected the R & M same position as mine, 03 620, should be the same with your S4.

have you tried fire it up?


roy-nexus-6

Quote from: pompetta on September 17, 2009, 03:41:38 AM
M = mendata(?) (feed) and R = ritorno (return).

I labeled mine with a sharpie before dismantling, but I'm away from my bike and I'm not much help.   :P

Ah, feed and return! Still not sure if they are in the right orientation, but now I have something new to google!

I would normally label everything, but I started this job just prior to a ride... and then it became a 'rush' job when I couldn't fit the breather without removing the tank :(

Quote from: simoniz on September 17, 2009, 06:04:56 AM
you have connected the R & M same position as mine, 03 620, should be the same with your S4.

have you tried fire it up?

Good to know it is the same as your bike! Yes, I've fired it up, it seems to run fine. Just don't want it to STOP running when I am 30mins from home.

EEL

Quote from: weemonster on September 17, 2009, 03:56:15 AM
Deficiente   is the italian for moron.

I think it was changed to DeAngelis as of 2 weeks ago.. ;D

Vin

2007 S2R 1K

Arrow full system + DP ECU + Mag wheels

Gus Duc

The Italian word fo " Moron" is:     LUCA [cheeky]

brad black

if you had the feed side going to the low pressure side of the regulator i don't think it would start, as the reg wouldn't let any fuel through.
Brad The Bike Boy

http://www.bikeboy.org

Grampa

Gaspar, Melchior and Balthasar kicked me out of the band..... they said I didnt fit the image they were trying to project. 

So I went solo.  -Me

Some people call 911..... some people are 911
-Marcus Luttrell

weemonster

Quote from: BucciMonster on September 19, 2009, 12:37:39 PM
Italian word for idiot or moron is scemo (masc.) or scema (fem.)

Pronounced shemo

My dad used to call me that quite often


scemo just means silly its not even as bad as stupid. which is stupido.

bdfinally

QuoteWhat is the Italian word for 'moron'.

"Britore" this week
The tyranny of the rat race is not yet final...HST

Speeddog

I don't have my bike in front of me.
Service manual is no help on it.

Owner's Manual has a pic, not sure how clear it is.

AFAIK, all of the '02 and later steel tanks will have the same inlet/outlet configuration.
- - - - - Valley Desmo Service - - - - -
Reseda, CA

(951) 640-8908


~~~ "We've rearranged the deck chairs, refilled the champagne glasses, and the band sounds great. This is fine." - Alberto Puig ~~~

jerryz

Italian word for Moron is ......BERLUSCONI

Rever_Corsa

How about MaleDucati, I always thought it was a great club name.