What did you just buy for your Ducati?

[Rudemouthsky]

A set of Pirelli Diablo's.

[Rudemouthsky]

[Rudemouthsky]

Mikuni DF62-702 Fuel Pump...matches the dimensions of the OE, but with an extra outlet



Plan to use this;



And hopefully that's all there will be to it?

Found a NOS 851/888 tank latch too (new on the right);

[Privateer]

[RonB]

Some of the detail pieces I've aquired are what tickle me the most; like these Driven D-Axis bar end mirrors from our sponsor Bellissimoto:

Also my Truck-Lite arrived...looks freakin awesome but I'm dissapointed in how heavy it is:

Looks awesome. Any pics installed? was it pnp or did you need to rewire harness?

[Rudemouthsky]

Looks awesome. Any pics installed? was it pnp or did you need to rewire harness?

It has an H4 connector, sooo..plug n play. I did have to buy the Motowheels billet adapter ring to make it work with the stock Monster bucket (I have a CF bucket, also from Motowheels)

But all this stuff is just sitting in boxes until I have all the parts needed to build a complete motorcycle. ..

[TitanMonsterS4R]

A 15K service for my S4R. My wallet is 

[oorahduc]

848 rear wheel + single sided swingarm + termignoni kit

[thorn14]

Pod filters. Installed em already. Barks a lot louder on WOT than my open airbox.

[Rudemouthsky]

Pod filters. Installed em already. Barks a lot louder on WOT than my open airbox.

The usual RU-1750's? Ironic,  I literally just bought:




Lookin forward to tuning my bike...

[koko64]

Whats the part number for those?

[Rudemouthsky]

Whats the part number for those?

RX-4040-1

They are a bit longer than the 1750's and are not angled like the 1750's but the flange is much shorter. Fitment may be a challenge. But my FI tank has a bit more room underneath than the carby tank. Inside dimensions of the flanges are the same. My 1750's got squashed pretty good, it'll be interesting to see how these fit. They sure as fk weren't cheap.

Best place to buy k&n filters in the States by far is Advance Auto Parts and apply the 40% off coupon.

[Desert Dust]

I'm wanting to put some pods on my s2r. Is there a less expensive route? This setup runs $280

[koko64]

I don't know what it is, but I got a thing for all those intake parts. They reek of the look of horsepower.
It's hard to get away from the cost, and you want the complete kit for your model.  I saw MW had a complete kit, it may have been the Corse Dynamics kit?

[thorn14]

I bought the beast kit from TPO on ebay for $194 used Louder, today it SEEMED smoother without any tuning, but I'm only running a DP ECU with the mixture tweaked.

That setup above with the red stacks is the Corse Dynamics right? I saw those on motowheels but they were out of stock when I checked, and I'm too cheap to pass up used performance parts