1000ds FCR Build

[koko64]

 

[Düb Lüv]

oh geez. i finally stopped procrastinating and ordered the rest of my port and polishing goodies. different shaped cartridge rolls and lots of cross buff pads.

sometimes i think somebody will order this stuff for me, but don't.

[koko64]

Well done.
No pressure

[Düb Lüv]

lookin much better, but still not done

[koko64]

Lookin' good. Started on the ports yet?

[Düb Lüv]

Lookin' good. Started on the ports yet?

Just on the exhaust port of one head. I did this polishing at work while waiting for parts. I still need to blend the valve seats before I can start with the finish polishing.

[koko64]

Hey DL. Any updates?

[Düb Lüv]

Hey DL. Any updates?

Today I'm going to baked my head in the oven to remove the valve guides. I bought the smallest polishers but they still hit the guides. Hopefully the guides will just slide out.

[Düb Lüv]

I think I finally have one head ported. I ran out of daylight to give it a final check over. There's a few original casting marks left but oh we'll. I'm sure those few minute places wont make a difference.


intake side


exhaust side

[koko64]

Nice work DL. Good onya for having a go at it yourself.

[thorn14]

So exciteddddddd. Looking nice.

[koko64]

 

[Graymonster]

Any news on this build DL?

[Düb Lüv]

Any news on this build DL?

Well, I bought a rescue 99 ss a week before the indy motogp, and now just getting around to fixin it. Knocked out my valve guides on the vertical head the other day. Started porting and polishing.

Ducatiz, it your see this I didn't forget about you. I've been super busy.

[Düb Lüv]

Graymonster kinda gave me a push to knockout the rest of my head work. I can say I'm done, as long as I don't critique myself.

I don't know why, but I have a feeling that when I get my valve guides installed and valves recut. The people doing the work will be like what the hell did this retard do. Oh well.