2014 version .. Fuel pump not priming

[cbcanada]

The out hose goes to the injectors, the other line goes from the injectors. (Pressure regulator, actually) where are your breather hoses going?

The breather hoses are routed the exact same way they were always

[cbcanada]

The out hose goes to the injectors, the other line goes from the injectors. (Pressure regulator, actually) where are your breather hoses going?

Okay it seems and this is just a guess but there is too much gas coming from the "out" hole.. Everytime i unplug the hose lots of fuel comes out.  I dont think the gasoline should be coming out that fast from the tank to fill up the out line that fast.

[cbcanada]

These hoses connected to the bottom of the fuel tank are the ones that are pissing out gas when i disconnected them.. Just the one on the bottom without the green tape. It was connected to the "out" connection on the bottom of the tank..

[cbcanada]

Okay i took out the fuel pump again and found this had come off...




"If i was educated, I'd be a damn fool"

[cbcanada]

Lol what an adventure.. Okay is that thing suppose to pop in? The o ring does not go inside the hole

[cbcanada]

Okay i popped it back in but those washers are too loose to hold it down. Are those washers the only thing thats supposed to secure it?

[SpikeC]

 There are spring clips that go over the washers.

[cbcanada]

Got the bike running!
One of the quick connect pumps wont "click" in now i guess from going in and out so much.. Do i just replace the i ring? Or i have to replace the connector?

[ducpainter]

Sounds like one of the tabs broke.

Get a new connector and o-ring.

Lube the o-ring before assembly.

[cbcanada]

Sounds like one of the tabs broke.

Get a new connector and o-ring.

Lube the o-ring before assembly.

Tab? Do you mean the part you squeeze to pull out. If so thats all good still.

[ducpainter]

Then it should still lock into place.

The o-ring just seals the joint and has no effect on the locking.

[cbcanada]

Then it should still lock into place.

The o-ring just seals the joint and has no effect on the locking.

The o-rings have swollen a bit it seems i can get into the hole past the o-ring thats why i was thinking

[ducpainter]

New o-rings are never a bad idea.

Like I said, always lube the o-rings for installation...even used ones.

[cbcanada]

New o-rings are never a bad idea.

Like I said, always lube the o-rings for installation...even used ones.

Lube it with?

[ducpainter]

A bit of grease lightly applied.

At the track we use what's on hand.

Chain lube works great and won't damage o-rings